SIGNATURE ON FRONT PANEL
SOUND / FUNCTIONAL CUSTOMIZATIONS
The customization of our products are not limited only to the look of your amplifier, they can also concern sound and functions. Although it is impossible to make a detailed list of all the possible customizations, below we will try to give you some guidelines. Every single request of customization will be evaluated to determine its feasibility and to allow us to provide the right estimate.
FINE TUNING CUSTOMIZATION
Although most of our customers are usually satisfied with the “stock” products, those who wish may request a service customized tuning of your instrument. On each amplifier it is in fact possible to act on specific parameters such as voicing, the gain or the equalizer to best suit the individual needs. The customization of these parameters is usually done through the replacement of specific electrical components and, where necessary, installing one or more micro-switches to easily recall settings created. You can request the fine tuning customizations both when placing your order or after.
EQUIPMENT OR OPERATIONS CUSTOMIZATION
In this category we put all the customizations that require substantial changes to the wiring diagram of the amplifier and must therefore be requested before the construction of the instrument.
-Installation of additional potentiometers
-Installation of features activated via footswitches
-Change type of valves used (eg: EL84, 6V6, EL34, 6L6, 6550, etc.)
-Change type of operation class of the power amplifier (eg: fixed bias, bias chatode, with / without negative feedback, etc.)
-Change to the output power of the amplifier
-Adding / Removing loop effects
-Installation of spring reverb
It should be noted that the customizations listed above are to be considered primarily as an example because their actual feasibility depends on the amplifier model chosen and the number of desired customizations. Each request will be evaluated on a single case basis.
|Tuning customization||hourly rate €40|
|Installing additional switches||from €30 per switch|
|Installing additional potentiometers||from €30 per pot|
|Installing controls activated by footswitch||from €90|
|Change the type of tubes used by the power amp||from €30|
|Installation of fx loop||from €90|
|Installation of spring reverb||€200|
|Custom chassis (*)||€200|
|Realization of fully custom amplifier||from €2,000|
(*) Required in the event that the requested customizations are not physically applicable on the original chassis. Learn the topic.